If your car s clutch slave cylinder is failing you can also expect to see some visible leaks.
Flutch stuck to floor no leaks.
Just because the mechanic saw no leak doesn t mean it s not leaking now.
My 1991 rx7 s clutch went so loose that it actually stuck to the floor and the car died.
I hand pumped my clutch for about three hours straight.
Seems like it has no compression fixing the clutch i bet one of the lines had been leaking clutch fluid for quite a while.
Could it be something with the clutch pressureplate flywheel.
Replacing the cable will allow you to engage the clutch and change gears once more.
Common reasons for this to happen.
Verify that your clutch slave cylinder it will be mounted on the transmission is not leaking.
Diagnosing a clutch pedal on the floor due to failed release bearing.
To my bleeder valve on slave cylinder and put the other end in my master cylinder reservoir.
Obviously my clutch is bleeding down.
You could damage the clutch the clutch fork or the transmission.
I work by myself.
Mechanical failure linkage pedal breaks pressure plate breaks clutch fork breaks or becomes detached or hydraulic failure the hose ruptures one of the cylinders fail or the fluid level drops below the pickup level.
You could damage the clutch the clutch fork or the transmission.
Now it won t start.
Trying to narrow it down before i have to pull the trans out.
So i was trying to two man method to bleed it myself.
If there are no fluid leaks at the master cylinder no swirl or bubbles in the clutch reservoir and the clutch pedal does not slowly descend with constant pressure then the master cylinder is likely working.
Verify all lines between are not leaking.
Check underneath your vehicle for any pools of liquid and check the engine bay too.
Still no pressure in clutch.
It started drove awhile then repeated the problem.
I was told to put a tube i used 1 4 line.
As mentioned earlier leaky cylinders can t maintain the requisite pressure to function properly and should be replaced.
And pump the hell out of the clutch.
Everything seems intact still.
Floor or engine bay leaks.
No leaking or anything.
Preparing the vehicle to check the clutch pedal for a failed release bearing.
Part 1 of 4.
Do not attempt to start the engine and drive the vehicle with the clutch pedal stuck all the way to the floor.
Do not attempt to start the engine and drive the vehicle with the clutch pedal stuck all the way to the floor.
All of a sudden clutch pedal fell to floor no pressure.
Ok so everything has been fine.
Still have full fluid.
There s only two ways the pedal can go to the floor.
No fluid leaks visible at slave cyl or lines.
