Gas Water Heater Thermocouple

If the pilot light goes out the thermocouple acts as a safety device by preventing the gas valve from opening and potentially filling the area surrounding the water heater with natural gas.

Gas water heater thermocouple.

Universal gas thermocouple includes universal adapter fittings and is compatible with screw in push in or clamp type pilot burners. For gas furnaces and 30 mv systems. When you re having trouble getting the pilot to stay lit it could be because the thermocouple needs to be replaced. It is designed for gas furnaces and 30 mv systems.

The thermocouple is part of the pilot assembly where one end is always in contact with the pilot flame while the other side is connected to the gas control valve. This signal keeps the gas valve open. The element is built for reliability and long life. On older style heaters with standing pilot lights the device is typically called a thermocouple while on newer units with electronic ignition the same or virtually the same device is called a flame sensor.

Positive positioning for quick insertion. Diy hot water heater repair. A faulty thermocouple or one that is simply dirty may consistently prevent the gas valve from opening or the pilot from staying lit. 4 7 out of 5 stars 189.

The honeywell 24 in. Honeywell home cq100a1005 u cq100a1005 replacement thermocouple for gas furnaces boilers and water heaters 36 inch. First shut off the gas valve on the water heater and the gas valve on the gas line near the heater. Reliance hot water heater gas control valve 100112336 9007884005 100093974 1 cavity thermostat compatible with reliance state a o.

The gas water heater thermocouple is the safety element that is designed to inform a gas control valve is the pilot flame on or off and open or close the gas to the main burner. A water heater or furnace thermocouple is a heat sensitive probe that sends an electric signal to the gas valve whenever the pilot is lit. A thermocouple or flame sensor is a device used to control gas flow in gas water heaters. The burner typically sits loosely or under clips in the burning chamber and just slides out.

Then unfasten the three nuts that hold the thermocouple and the two gas tubes to the valve.