If you can upgrade to a heat press then do it.
Heat transfer vinyl not staying on after washing.
My heat transfer vinyl is starting to peel off after going through the washing machine solution.
If easyweed is heat pressed too long or pressed at too high of heat it will not stick to the garment.
Sometimes everything looks perfect but that s not always the case.
Htv needs time to cure.
Or maybe you could tell that your htv was barely sticking after the press so you weren t all that surprised to notice the heat transfer vinyl coming off but you really.
Sounds like your vinyl didn t adhere very well.
Find out how to fix your pesky peeling heat transfer vinyl right away.
Heat again for 25 seconds.
Subscribe to expressions vinyl s channel here https goo gl y3jpi4 there is a lot of reasons why your heat transfer vinyl could be peeling off after the f.
Maybe you thought that it adhered properly but after a few washes you noticed the heat transfer vinyl peeling off.
Put a piece of kraft paper not the telflon sheet over the garment.
Is your htv not sticking to your shirt or bag.
This heat allows the adhesive to sink down into the fibers of your shirts bags pants etc.
It may also weaken the adhesive causing the print to peel off.
For the same reasons you do not wash the fabric in hot water you should not use a dryer for fabric with vinyl print.
The more pressure you apply the better it will adhere to the shirt in a flat and uniform fashion.
The best way to dry a garment with vinyl print is to hang it to dry.
Wondering why your heat transfer vinyl is not sticking.
Apply a good amount of pressure while you iron the heat transfer vinyl to the shirt.
Transfer not sticking to the garment.
After application the adhesive needs time to harden and cool without interruption.
The heat from the dryer will damage the print and cause it to shrink.
If you re cutting more than one color and using small pieces you can put both colors onto the mat.
The adhesive on heat transfer vinyl is activated by heat.
Do you need a heat printing pillow.
After mirroring the baseball design place your heat transfer vinyl onto the cutting mat with the shiny side down.
Are you using the correct settings.
After you have sprayed the design put it back on the heat press.
Iron vs heat press.
There are a lot of reasons this could be happening but the four most common reasons are easily solved with a few tips.
Remove garment stretch the image again.
Remember to use a hard flat surface to iron the htv to your shirt.
Let your vinyl sit without washing for at least 24 hours.
When too much pressing happens on a design it is almost as if the adhesive gets completely burned off.
